GR Golf tips for Seamless Seat Cover Installation

for molded in place cushions

compatible with:

· Club Car 2004+ Precedent w/ OEM cushion

· Yamaha 2007+ Drive w/ OEM cushion

Required Tools: Stapler, Scissors or Utility Knife

Backrest Cover:

	Place Backrest Cover over existing seat bottom cushion. Center the cushion within the vinyl form.
	2. Turn backrest and cover over so that the cushion is laying plastic side up and staple cover in place as shown. (Tips: staple the top side of the backrest first, starting in recessed area and working out, stretch evenly to maintain alignment, visually check alignment)
3. Trim excess vinyl using a scissors or utility knife. You can increase the finished look of your re-upholstered seat back by taking a few extra minutes and stapling the vinyl edges down into place, as shown. Finished part should look similar to pictured item below.

Bottom Cover:

	Place Bottom Cover over existing seat bottom cushion. Center the cushion within the vinyl form.
	2. Turn seat and cover over so that the cushion is laying plastic side up and staple cover in place as shown. (Tips: staple the long sides of the seat first, starting in the center and working out to ends, stretch evenly to maintain alignment, visually check alignment)
3. Trim excess vinyl using a scissors or utility knife. Finished part should look similar to pictured item.